EPDM Rubber Brick Grab – 86mm x 60mm

Product Information

Industrial-Grade Rubber Brick Grab for Material Handling

Protect your materials and machinery with this high-performance rubber brick grab. Specially engineered for heavy-duty material handling, this profile acts as a critical replacement insert for hydraulic grab jaws. Designed specifically for full compatibility with the Kinshofer KM 331, it delivers a secure, non-slip hold on bricks, concrete blocks, paving slabs, and tiles during transport across busy construction sites and yards.

The 86mm x 60mm profile provides a broad, cushioned surface against heavy loads. By absorbing clamping force and distributing pressure evenly, this brick grab rubber prevents costly mechanical crushing, chipping, and face-marking on fragile masonry units while maintaining total load integrity.

Premium EPDM Construction & Secure Holding Power

Molded from an ultra-durable 80° Shore A EPDM rubber compound, this KM 331 rubber insert provides high tensile strength, firmness, and compression resilience. Unlike standard rubbers that harden or breakdown in extreme environments, our EPDM formula excels in harsh outdoor conditions, resisting UV rays, ozone, frost, and weathering over thousands of continuous operational cycles.

Used extensively as a brick stack grapple rubber, its high-friction profile ensures maximum traction on wet, dusty, or smooth surfaces. This prevents dangerous load slippage, protecting ground workers while speeding up transport times for cranes and excavator attachments.

Premium EPDM Construction & Secure Holding Power

• Engineered for Kinshofer KM 331: Directly replaces worn-out factory pads for quick, hassle-free installation on hydraulic attachments.
• High-Clamping Efficiency: Resilient 80° Shore A EPDM holds heavy packs firmly without applying damaging point-pressure.
• All-Weather & UV Resistant: Will not dry out, split, or rot when exposed to constant sunlight, rain, or freezing temperatures.
• Versatile Length Options: Available off-the-shelf in 1m and 1.25m lengths to fit varied jaw widths and custom setups.

Applications

• Hydraulic brick stack grapples, mechanical grabs, and crane attachments.
• Palletised and unpalletised brick, block, and paving slab handling.
• Construction sites, brickworks, masonry supply yards, and builder merchants.
• Logistics, haulage, and lorry-mounted crane operations (HIAB handling).

How to Install

1. Inspect & Clean: Remove the old, worn brick stack grapple rubber from the grab jaw channel. Clean out any dirt, mortar, or debris from the retaining channel.
2. Align the Profile: Slide or position the 86mm x 60mm KM 331 rubber insert along the length of the grab jaw.
3. Trim if Required: Measure the jaw face and cut the EPDM extrusion neatly to length using appropriate rubber-cutting tools if using custom sizing.
4. Secure in Place: Ensure the insert is fully seated into the attachment frame and mechanically secured per original equipment manufacturer (OEM) guidelines before testing under load.

If this is not the product you are looking for, take a look at the rest of our range of rubber seals and extrusions.